General Tool List:

Metal Tool Box- with at least one tray; non-metal tool box is optional
Digital Multimeter- an analog meter is optional
Calculator- a basic model is recommended
All Pliers - Diagonal, duck billed, needle nosed, slip joint and water pump
1/4" Socket Drive Set- with 12 -point sockets from 1/4" to 9/16" by        16th " increments, inluding 11/32 " 1/4" Drive extensions - 6" and 10"
3/8" Socket Drive Set - with 12 point sockets from 3/8" to 1" 3/8" drive extensions - 6" and 10"
Combination open end/box end wrench set- from 1/4" to 1".  Duplicates are         recommended in the 7/16", 1/2", and 9/16" sizes, including 11/32 "
Straight slot (common) and Phillips Head screwdrivers-Long & short shaft
Phillips #1, #2, #3 screwdrivers, stub and regular lengths
Slotted #1, #2, #3 screwdrivers stub and regular lengths
Pick set, straight, hooked, angled, right angle
Speed handle - 1/4" drive
#1, #2 Easy out screw extractor or kit
Drills - 5/32" and 7/64" left hand preferred
Plastic faced Mallet
Ball peen hammer - not over 8 oz.
Pin punches, drifts- 3/32" and 1/8" pin punch, center punch, and a 1/4" brass drift
Cold Chisel
Thickness, or feeler gauges
Pencil Compass
Steel combination square - with 45 and 90 degree angles + 15" or 18 " ruler
Files - medium cut for metal use 8" half round, 8" mill, 8" round, and a handle
Vernier Caliper - digital optional
0 to 1" outside micrometer - digital optional
One tap and one die holder with 10/32 tap and die, 8/32, and 6/32
Steel rule - 1/64 "  increments, 6 " length
Scissors - not over 6"
Utility knife
"Exacto"  knife
Flashlight
Inspection Mirror
Hex key or Allen wrench set
Hacksaw frame and blades 2 each 24 & 32 teeth per inch
Magnifying Glass - at least 10X
Safety Equipment - Safety Glasses, dust masks, welding goggles & gloves, earplugs,                             latex gloves
Total: $400.00
Cost is estimated. Actual cost may vary